Agfa Printer Uživatelský manuál stáhnout pdf (Strana 18)

:ANAPURNA L/XL OPERATOR MANUAL

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]18] 8/09/2006]

7. Printing Table.

7.1. General information

- Woven Conveyor belt

- Transport is done by a step-motor

- On the table are 2 vacuum-zones with a fixed strength.

The table is evenly divided in a right (1) and a left (2) side,

which can be switched on in that order.

- When printing on a banner/paper type of roll media, only the right (1) vacuum

side should be used. (Even when the media width is almost the engine width)

- When printing on two rigid media, both vacuum tables must be used.

7.2. Belt Tension control

- 1) if the belt is touching the left or right guide, on the underside of the table.

- 2) remove the metal covers on the backside (both left and right), rotate the screw

at the REAR stand to CW or CCW to control the tension.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Komentáře k této Příručce

Žádné komentáře

Agfa Printer Uživatelský manuál Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Tiskárny Agfa Printer