Agfa Printer Uživatelský manuál stáhnout pdf (Strana 26)

:ANAPURNA L/XL OPERATOR MANUAL

AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]26] 8/09/2006]

9. Media Setup.

9.1. Roll to Roll

9.1.1. Auto Feed System

The Auto feed system has two tension bars, holding a constant tension.

Those tension bars prevent distortion and waves on the media.

The Rear roll bar will unwind the media, with a constant tension and height

controlling. These are acquired from the “signal sensors”.

The Front roll bar will wind the printed media, holding a constant tension to reduce

distortion. Wind direction can be reversed.

Make sure you always insert the “Tension Roll Bar” at a correct way.

The ball bearing must be inside the guide.

When inserting, make sure both side’s are positioned as high as possible into

the left and right unit, then gently lower both sides, the bar must stay completely

horizontal for best use.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Komentáře k této Příručce

Žádné komentáře

Agfa Printer Uživatelský manuál Strana 26

Komentáře k této Příručce

Související produkty a manuály pro Tiskárny Agfa Printer